Skip to content
Request a Quote + Certification

Quality System

Quality System & Standards

The standards, traceability and management arrangements that govern the work described on this site.

Standard ISO/IEC 17025:2017Disciplines 3

Overview

Calibration is performed by laboratories accredited to ISO/IEC 17025:2017. Certificates are issued under the performing laboratory's own accreditation scope. That scope determines whether a given measurement, range and uncertainty were actually covered, not the certificate alone. Each request is checked against the applicable scope before it is quoted.

Standards Referenced

Work described on this site is performed under ISO/IEC 17025:2017.

Accreditation named anywhere here is the performing laboratory's, and its limits are the limits of that laboratory's published scope. Measurements outside the scope are reported as non-accredited and identified on the certificate rather than quietly included. Each accreditation statement names the laboratory that holds it.

What a quotation includes is set out on the accreditation documentation page.

Metrological Traceability

Measurements are traceable to the SI through NIST, documented as an unbroken chain of comparisons, each carrying a stated uncertainty. Certificates state the reference standards used and the reported measurement uncertainty, with the decision rule applied wherever a statement of conformity is given. Where adjustment or repair occurred, results are reported both before and after. An uncertainty reported smaller than the laboratory's scope CMC is corrected as a finding before issue, not published as a figure.

The traceability statement belongs to the measurement, not to the building. On the certificate you will find the reference standard used, its calibration status at the time, and the chain by which it reaches the SI unit. Should that reference later fail its own calibration, the intervening work is reviewed and affected customers are contacted.

Equipment and Maintenance

Equipment categories handled through this intake include bridge, gantry and cantilever coordinate measuring machines, portable articulated arms, granite surface plates, gauge blocks, and ring and plug gauges. Documented procedures cover request review, method selection, result review and release, and a complaints-and-appeals process. Accredited and non-accredited items are identified separately on both the quote and the resulting certificate so a buyer can see which figures carry accredited scope. Where a purchase order cites ANSI/NCSL Z540.3, the guard banding and 2% probability-of-false-accept rule it requires are addressed at the programme level, documented rather than assumed.

Reference equipment is uniquely identified, held under controlled conditions, and recalibrated on a defined interval that is shortened when drift data justifies it. Equipment that is damaged, overloaded, or shown to give suspect results is removed from service and labeled until it has been checked and returned to use in writing.

Management System

The work sits inside a documented management system:

  • 01

    Controlled documents

    Procedures carry issue and revision status.

  • 02

    Retained records

    Retained for a defined period and retrievable against a certificate number.

  • 03

    Audit and review

    Internal audit and management review run on a schedule.

  • 04

    Corrective action

    Nonconforming work and improvement actions are tracked to closure, and their effectiveness is checked afterwards.

Impartiality and Complaints

Risks to impartiality are identified and controlled, and results are reported on their merits regardless of the commercial outcome. Complaints and appeals are a formal input to that system — the process, including the response commitment, is set out on the complaints policy page. How results should and should not be read is covered on the disclaimer page.

Need paperwork for an approved-supplier file?

Scope, method statements and traceability detail are supplied with the quotation.

Pricing is set out in writing and sent by email.
Request a Quote + CertificationEmail us